Lumasense-technologies LumaSoft Gas Multi Point 7860 Uživatelský manuál stáhnout pdf (Strana 33)

Chapter 3

_________________________________________________________________________

________________________________________________________________________

BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S

7810 and 7860 Page 33 of 194

Enter the IP address of the Gas Monitor into the IP-address field as

shown in Figure 3.8.

Figure 3.8 Enter the IP Address of the Gas Monitor.

Refer to Section 2.2.4 to find the IP address of the 1412i/1314i/3434i

Gas Monitor.

Press the OK soft-key to close the System Configuration Setup

window. Proceed to Section 3.2 in order to create a new task.

If the creation of a new task failed the following message box will

appear. It is caused because LumaSoft Gas is unable to communicate

with the Gas Monitor through Ethernet (TCP/IP).

Figure 3.9 Communication failed with the Gas Monitor.

Please make sure that the Ethernet (TCP/IP) interface cable between

your network and the 1412i/1314i/3434i Gas Monitor is securely

connected.

Please ask your Administrator to check the TCP/IP settings of the

1412i/1314i/3434i Gas Monitor as described in Section 2.2.4.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 193 194

Žádné komentáře

Lumasense-technologies LumaSoft Gas Multi Point 7860 Uživatelský manuál Strana 33